Suzuki DF200A 200 HP In-Line 4 EFI Outboard Motor

The Suzuki DF200A is a 200 HP outboard built around a 2,867 cc in-line four-cylinder DOHC 16-valve engine with multi-point sequential electronic fuel injection. It has electric start, remote steering, power trim and tilt, and a recommended transom height of 25 inches.

The powerhead uses a timing chain, solid-state direct ignition and a 12V 44A alternator, with an 8.5-quart (8.0 L) oil pan. A two-stage gear reduction system and offset driveshaft drive a 2.50:1 gearcase, and the operating range is 5,500-6,100 RPM. An over-rev limiter, low oil pressure caution, tilt limit, fresh water flushing system and the Suzuki Anti-Corrosion System are fitted.

Weight is 529 lbs with mechanical shift or 531 lbs with drive-by-wire. The propeller is optional and not supplied as standard, with pitches from 17 to 27.5 listed for selection.

Highlights

• 200 HP in-line 4, DOHC 16-valve, 2,867 cc

• Multi-point sequential EFI, electric start

• Power trim and tilt, remote steering

• 2.50:1 gear ratio, two-stage gear reduction

• 529 lbs mechanical shift / 531 lbs drive-by-wire

• Propeller optional (17-27.5 pitch selection)

Specifications

Good to know

• Confirm shaft length, controls and propeller rotation against your boat before ordering, and stay within the maximum horsepower on the boat's capacity plate.

• Installation, rigging and commissioning by a qualified marine technician are recommended; follow the manufacturer's pre-delivery and break-in procedures.