Suzuki 115 HP Outboard Motor, 20" Shaft

A Suzuki 115 HP outboard with a 2,044 cc four-cylinder DOHC 16-valve engine, multi-point sequential electronic fuel injection and a 20-inch shaft. It has electric start, power trim and tilt, and remote steering, with a tiller kit optional.

The engine uses the Suzuki Lean Burn Control System, a timing chain, solid-state electronic ignition and a 12V 40A alternator, with a 5.8-quart (5.5 L) oil pan. A two-stage gear reduction system and offset driveshaft feed a 2.59:1 gear ratio, and the operating range is 5,000-6,000 RPM. Protection features include an over-rev limiter, low oil pressure caution, tilt limit, a fresh water flushing system and the Suzuki Anti-Corrosion System.

The motor weighs 401 lbs, and the recommended transom height is 20 inches. The propeller is optional and not supplied as standard.

Highlights

• 115 HP four-cylinder DOHC 16-valve, 2,044 cc

• Multi-point sequential EFI, Lean Burn Control

• 20" shaft, 401 lbs

• Electric start, power trim and tilt

• Remote steering, tiller kit optional

• Propeller optional, not supplied as standard

Specifications

Good to know

• Confirm shaft length, controls and propeller rotation against your boat before ordering, and stay within the maximum horsepower on the boat's capacity plate.

• Installation, rigging and commissioning by a qualified marine technician are recommended; follow the manufacturer's pre-delivery and break-in procedures.