Miller Syncrowave 210 AC/DC TIG Welder (907596)

The Miller Syncrowave 210 (907596) is an AC/DC TIG and DC stick inverter with a 210 A maximum output, supplied ready to weld with torch, foot control and factory-installed running gear. It runs on 115 V or 230 V single-phase input and is rated at a 60% duty cycle.

Setup is a matter of choosing the process (AC TIG, DC TIG or DC stick) and setting amperage for the material thickness. Squarewave AC output with adjustable AC balance controls oxide cleaning for aluminum. The inverter delivers full output from 230 V while drawing less than 30 amps, Auto-Line accepts 115-230 V input without relinking, and Multi-Voltage Plugs let the cord connect to common 120 V or 230 V receptacles without tools. A front-panel memory card port allows software updates.

Included: Syncrowave 210 power source, 10 ft (3 m) primary cord, two MVP plugs for 115 V and 230 V, 12 ft (3.8 m) 150 A TIG torch with Dinse connector, 12 ft (3.8 m) work cable with clamp and Dinse connector, electrode holder with Dinse connector, RFCS-14 foot control with 20 ft (6 m) cord, regulator/flow gauge with gas hose, and factory-installed running gear with EZ-Change low cylinder rack.

Highlights

• AC TIG, DC TIG and DC stick, 210 A maximum

• 115 V or 230 V single-phase input with MVP plugs

• Adjustable AC balance for aluminum

• 150 A TIG torch and RFCS-14 foot control included

• Running gear with EZ-Change low cylinder rack

• Regulator/flow gauge and gas hose included

Specifications

Good to know

• Check the input power requirements (voltage, phase and amperage) against your supply before ordering.